Thursday, October 21, 2010

Backing plates done


The backing plates are finally done! The biggest challenge was the little leaf springs that hold the adjusting stars in place. All mine were broke off. I tried to research on how this could be fixed, by suggestions were a little vague, so you can see on the picture below on what I did. The brakes on the Classic VW are manual adjusting, which means that every so often you need to jack the car, insert a screwdriver through the drum and rotate the stars to tighten the brakes. Without the leaf springs, the star could back off, and cause the brakes to be less effective.




I drilled an 1/8 hole throuh the new little leaf spring (from Wolfsburg West) and drilled into the plate. I dripped some loctite in the hole and put in a #6 x 1/2 sheet metal screw to hold it together






No comments:

Post a Comment